SexLab animations don't work

[Omnishade]

I've installed SexLab v1.63 on a standard SE install, XP32 skeleton, SLAL and some SLAL packs. Ran FNIS successfully but when an animation starts the characters are just standing there doing nothing. I've had many big installs before so I know what I'm doing, but now I can't figure out what's wrong. I might have forgotten something.

 

Spoiler

Edited July 7, 2022 by RoninDog

[Just Don't]

 Did you check what are these 12 warnings? Ideally you want to have exactly 0 warnings. Read what FNIS says and address all of them. Most likely these are *.hkx incompatible files, if that's the case you'll need to remove the mods providing said animation files, get mods ported or made for SE and then run FNIS again. When you have no warnings or errors you should be okay.

[Omnishade]

3 hours ago, Just Don't said:

 Did you check what are these 12 warnings? Ideally you want to have exactly 0 warnings. Read what FNIS says and address all of them. Most likely these are *.hkx incompatible files, if that's the case you'll need to remove the mods providing said animation files, get mods ported or made for SE and then run FNIS again. When you have no warnings or errors you should be okay.

 

Yes, they are only "inconsistent mod, the number of animations does not correspond to the behavior file" which has never been a problem before. I just removed selective animations that I wasn't going to use. I also had one warning about an outdated behavior file, which was an LE mod. Replacing that mod with the SE version didn't help however.