Jump to content

UUNP Micro Stutter Solution found


Recommended Posts

Posted

So I have been plagued with Micro Stutter with modded UUNP Armor.

I tried everything, deleting mods, compressing the textures of the sets to a ridiculous degree but no luck.

 

I have found the solution.  Since I was using UUNP  I used my own custom preset. In the preset I had some values going over and under 0 and 100. This was the cause.  So I set those values between the 0-100 limit and Boom  No more stutter.

 

Luxury Collection, Bless Armor, Demon Hunter sets    ...0 Stuttering

 

Also If you have WeightMorphs don't set the value more/less than 0-100.

 

 

Posted

So I have been plagued with Micro Stutter with modded UUNP Armor.

I tried everything, deleting mods, compressing the textures of the sets to a ridiculous degree but no luck.

 

I have found the solution.  Since I was using UUNP  I used my own custom preset. In the preset I had some values going over and under 0 and 100. This was the cause.  So I set those values between the 0-100 limit and Boom  No more stutter.

 

Luxury Collection, Bless Armor, Demon Hunter sets    ...0 Stuttering

 

Also If you have WeightMorphs don't set the value more/less than 0-100.

 

Sounds like your CPU was struggling with your installation of physics. Any weight that's not 0 or 100 is an interpolation between the two and can become quite performance heavy when you factor in physics that affect that interpolated/morphed mesh.

 

Can't say how bad it is for HDT because I never noticed anything like that back in the day ( when i used HDT ), but it can cause a lot of problems for SMP users with weird artifacting and mesh distortions.

Posted

scratch that 

 

I don't think it was the bodyslide values.

 

It was WeightMorphs that caused the micro stuttering,

 

Wore a High Texture, fully Hdt set  with just weightmorphs at 0 and stuttering starts but when I turned it off  ... not a single frame drop or stutter,   On a new game too

 

Sucks I really liked Weightmorphs 

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...