SFCO NobleBedDouble 2 Collision Help(SOLVED)

[arlvent21]

EDIT: 

Never mind, fixed it by myself after an hour of messing with NifSkope.

 

Hi i would like to ask help from you guys on how to remove the collision of the encircled part of the Noble Bed Mesh(SFCO - Snazzy Furnitures and Clutters Overhaul) so after a SL animation, the Player and the NPC can clip through the upper beam, before i used SFCO i was using this mesh for vanilla beds but unfortunately SFCO has its own mesh.

 

I have NifSkope and i don't have the knowledge on how to use it but it helped me to identify on what texture is the object using.

[Delta1092]

Any chance you could pass on your wisdom and explain how you did it?

[arlvent21]

On 2/14/2020 at 1:55 PM, Delta1092 said:

Any chance you could pass on your wisdom and explain how you did it?

I'll show you tomorrow i'm not at home right now.

[arlvent21]

- Choose 1 based on your personal preference, this will be our template for the bed but I strongly recommend you to not use the No Beam since you're using SFCO's design.

 

 

- Open 2 Instances of NifSkope, 1 For the Template and the other one is for the SFCO Bed. The one on the left will be NifSkope #1 and the one on the right will be NifSkope #2, this will be our reference for the next step.

 

- NifSkope #2 Will be the SFCO's Noble Bed 02 If you're using the Replacer version, you'll only have to open noblebeddouble02.nif but if you're using the Mix n Match version, you'll have to open noblebeddouble02.nif and GM_noblebeddouble02_colorXX.nif so it means you have to do the steps below again and again until you finished covering up all Noble Bed Double.

 

-  Under BSFadeNode of NifSkope #1, right click "16 NiTriShape > Block > Remove Branch. Then it should look like this.

 

- On NifSkope #2 do this on every NiTriShape numbers(16,20,24,27,32,37,42) one by one.

Right Click > Block > Copy Branch 

Then back to NifSkope #1

Right Click BSFadeNode > Block > Paste Branch

After doing it individually, on NifSkope #1 and #2 Click the "Show Collisions"

 

- Well as you can see now NifSkope #1 has SFCO Bed Design with no Collision on 4 sides.

 

- Now on NifSkope #1, File > Save As > The Elder Scrolls V - Skyrim Folder > Data > Meshes > Furniture > Noble > Save.

 

And you're done.

[Delta1092]

Thank you so much!