SD+ Install issue.

[Syldis]

Hi!

 

I've recently tried to install the newest version of sanguine's debauchery enhanced on a brand new save. I followed the mod page instructions, but the mod seems like it froze during the install process. It's telling me to wait for quests to update, but it won't progress further than that.

 

I'll attach some screenshots in case it makes the issue clearer.

 

Any help would be much appreciated.

 

[foreveraloneguy]

"Updating quests requires that you exit all menus." Also, you should have gotten a message that you needed to save and reload.

[Syldis]

2 minutes ago, foreveraloneguy said:

"Updating quests requires that you exit all menus." Also, you should have gotten a message that you needed to save and reload.

I might be doing this wrong, but I waited 30 min outside MCM without any message popping up. How long should it take?

[Adviser69]

Depending on the system, usually less than a minute or two. Load the mod on a fresh save or character, then create another fresh save with the mod active, and reload that new save. Also, you made sure to have Sexlab Dialogues installed yes? Without that you won't get messages for the mod at all. Also make sure you have Sexlab Aroused, ZaZ animations and Devious Devices, these are hard requirements as well.

[Syldis]

20 minutes ago, Adviser69 said:

Depending on the system, usually less than a minute or two. Load the mod on a fresh save or character, then create another fresh save with the mod active, and reload that new save. Also, you made sure to have Sexlab Dialogues installed yes? Without that you won't get messages for the mod at all. Also make sure you have Sexlab Aroused, ZaZ animations and Devious Devices, these are hard requirements as well.

I think my sexlab aroused is outdated. Is it normal for the MCU menu to say it's version: 0 before the whole initialization process is over?

 

I'm going to update aroused and see if it helps. Thank you for all the tips.

 

[Adviser69]

3 hours ago, Syldis said:

I think my sexlab aroused is outdated. Is it normal for the MCU menu to say it's version: 0 before the whole initialization process is over?

 

I'm going to update aroused and see if it helps. Thank you for all the tips.

 

Actually, if it's the MCM for SD+, then yes. DeepBlueFrog had some reason for not doing a version change for the MCM menu, so it will show 0 with the latest SD+ version.